Canfield HVAC, since 2003
Canfield HVAC has been in business since 2003, and Steve Canfield (owner, chief HVAC technician) has been in the HVAC business since 1998. His training prior to starting the business was primarily in commercial maintenance and service. However, the majority of our business became residential new installation and maintenance. We were also involved in commercial installation, along with commercial and residential service. We even started installing gas and wood fireplaces in 2007. Our emphasis has shifted in the last couple of years, as we are now becoming primarily a service company.
Our Focus
Canfield HVAC is different than other companies. We are not primarily concerned with selling new equipment but instead stretching the life span and efficiency of current equipment.
Our Services
Service call minimum: 1.5 hours
Service call includes the labor to complete the following:
- capacitor replacement
- ignitor replacement
- check and top off AC charge
- most control boards
- blocked drain or vent pipe clearing
- contactor replacement
- pressure switch replacement
- flame sensor clean/ replace
- limit switch replacement
- annual maintenance
- thermostat replacement
- sequencer replacement
- fuse replacement
- disconnect replacement
- roll out switch replacement
- AC coil cleaning
Some repairs require additional labor, these hours are total billed not on top of the service call.
- Control board: 1.5-2 hours
- Furnace blower motor: 2-2.5 hours
- Ac fan motor: 2-2.5 hours
- Automatic gas valve replacement 2-2.5 hours
- Freon leak repair: quoted individually
- compressor replacement: 8 hours
- heat exchanger replacement: 8 hours
If you need us to look at your furnace or air conditioning system, please feel free to call or text Steve at (208) 440-1927 or email him at canfieldhvac@gmail.com